|
 |
 |
 |
 |
 |
|
Deck Winch bottom plate |
Stern Cleat |
Stern Ladder Backing Plate |
Stern Railing |
Port Gate Stanchion |
|
 |
 |
 |
 |
 |
|
Port Stern Railing |
Starboard Railing |
Starboard Gate |
Starboard Side Stanchion |
Cockpit locker hinge screws |
|
 |
 |
 |
 |
 |
|
Starboard Fuel Fill & Scupper |
Starboard Gate Stanchion |
Stern Locker |
Stern Rigging |
Stern Stanchions |
|
 |
 |
 |
 |
 |
|
Bow Stanchions support and Water tank
fill. |
Bow Stanchion support and bow cleat
support. |
Port Middle Gate support |
Port Gate Stanchion |
Starboard Gate Stanchion |
|
 |
 |
 |
 |
 |
|
Cockpit Locker Hinge |
Stern Back Rail Support |
Single Stanchion Gate Support |
Port Stanchion Support |
Wind Generator Support |
|
STRENGTHENING WHAT'S THERE
So if the original
stuff worked for almost 25 years why do you have to change anything.
Good question and the answer can be seen in some of the pictures
above. You should have noticed the cracked fiberglass backing
disks, water penetration around the bolts as well as rusted bolts...
to name a few. So my progress to date is as follows... |
|
 |
 |
 |
 |
 |
|
Starboard side new stanchion |
Port side forward stanchion |
Port Stern Cleat |
Starboard Stern Cleat |
Port side new stanchion |
|
 |
 |
 |
|
|
Port side stanchion gate and brace |
Vice Grips help to remove the nuts if
you are alone. Be sure to tie off the handle so you don't loose
it in the bilge. |
You can do this by yourself but it does
make for a lot trips up and down. |
Work
is still in Progress.... |
|
Top
Back
to Welcome Page
|
